Winding method

1. Check the winding amount of the reel (generally marked on the reel or packing box), and select the appropriate fishing line model.

2. Install the fishing line wheel on the fishing rod and close the check switch of the fishing line wheel.

3. Knot one end of the line, pass through a guide ring of the fishing rod, open the outlet ring of the fishing wheel, tie the line to the wire wheel, close the outlet ring, stretch the fishing line, and check and ensure the firmness of the bolt.

4. Keep the fishing line straight and tight, and start to rotate the fishing wheel rocker at a constant speed to wind the line.

5. When the winding height is about 1.5-2 mm lower than the edge of the thread wheel, do not wind more or less, or it will hinder you from correctly throwing the line. Keep the line straight and tight, stop winding and cut the line.

6. Then fix the fishing boat to the fishing wheel seat on the fishing rod to prepare for fishing. Although the drum type fishing line wheel is not big in shape, its line capacity is comparable to that of spinning type line wheel.

Wheel loading method

1. Install the fishing line wheel on the fishing rod (closed state).

2. Turn on the check switch of fishing boat, turn over the outlet ring of fishing boat, pull out the line, close the outlet ring, and pass the line through the guide ring of fishing rod in turn.

3. Fasten the falling line, tighten the fishing rod sections, and close the fishing boat backstop.

Line throwing method

1. Turn on the check switch of the fishing boat, turn the rocker, adjust the line falling to the appropriate position, and close the check switch.

2. Hook the fishing line with the index finger, turn the head sideways and send the rod back. The best distance between the rod and the ground is the line falling to the ground.

3. When the pole is in front of the side and the ground is at a 45 degree angle, the line will be released by shaking force and the line drop will be ejected.

4. When the line falls into the water and the line feeding is finished, shake the rocker, close the outlet ring, tighten the fishing line, and put the rod on the pole frame.

Take up method

1. The fishing line should be kept tight and straight with the rod at an angle of 45 degrees to the ground.

2. Rotate the wheel at a constant speed, keep the fishing line tight and straight, and adjust the tightness knob of the fishing wheel according to the size of the fish force.

3. After the fish is collected, put the rod on the rack, and the fishing boat shall not touch the ground to get dirty and scratch.

Wheel unloading method

1. Turn off the check switch and take down the dropper.

2. Tighten the thread with your fingers and shake the rocker. 3. Pin the thread to the wire wheel and wire piece.

4. Unload, clean and install the wheel.